MetalworkingFun Forum › Machining › Projects v
A stainless steel boma

Thread Modes
A stainless steel boma
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#21
06-05-2015, 11:03 AM
I don't believe in "lube" for machining, I'll use cutting fluid, mist, compressed air.
I just figure trying to "lubricate" the cutting action is contrary to the goal sought.
Maybe I'm too capricious or punctilious Rotfl .

Steve

Smiley-eatdrink004
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
A stainless steel boma - by DaveH - 04-24-2015, 11:22 AM
RE: A stainless steel boma - by DaveH - 04-24-2015, 11:34 AM
RE: A stainless steel boma - by DaveH - 04-24-2015, 11:50 AM
RE: A stainless steel boma - by f350ca - 04-24-2015, 12:45 PM
RE: A stainless steel boma - by DaveH - 04-24-2015, 01:00 PM
RE: A stainless steel boma - by DaveH - 04-27-2015, 10:15 AM
RE: A stainless steel boma - by DaveH - 05-25-2015, 11:59 AM
RE: A stainless steel boma - by DaveH - 05-25-2015, 01:30 PM
RE: A stainless steel boma - by Roadracer_Al - 05-25-2015, 09:52 PM
RE: A stainless steel boma - by DaveH - 05-26-2015, 01:13 PM
RE: A stainless steel boma - by dallen - 05-26-2015, 03:19 PM
RE: A stainless steel boma - by DaveH - 05-29-2015, 02:51 PM
RE: A stainless steel boma - by dallen - 05-29-2015, 03:33 PM
RE: A stainless steel boma - by DaveH - 05-29-2015, 04:30 PM
RE: A stainless steel boma - by DaveH - 06-04-2015, 12:36 PM
RE: A stainless steel boma - by Vinny - 06-04-2015, 04:15 PM
RE: A stainless steel boma - by DaveH - 06-04-2015, 04:50 PM
RE: A stainless steel boma - by dallen - 06-04-2015, 05:16 PM
RE: A stainless steel boma - by Mayhem - 06-05-2015, 08:49 AM
RE: A stainless steel boma - by EdK - 06-05-2015, 10:42 AM
RE: A stainless steel boma - by stevec - 06-05-2015, 11:03 AM
RE: A stainless steel boma - by DaveH - 06-05-2015, 06:54 PM
RE: A stainless steel boma - by PixMan - 06-05-2015, 07:01 PM



Users browsing this thread: 5 Guest(s)