|
Help Rotary table want to make good decision
|
06-05-2015, 10:49 AM
(06-05-2015, 10:42 AM)EdK Wrote: For that mill, I'd get the 6". You can always use a larger fixture plate on the 6" if you need a larger surface for some projects.see I get varied opinions but that's good keep em coming yes Ed was thinkin same thing how bout where to get correct dividing plates for the Vertex? |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Rotary table want to make good decision - by Kennyv - 06-05-2015, 09:37 AM
RE: Rotary table want to make good decision - by dallen - 06-05-2015, 10:18 AM
RE: Rotary table want to make good decision - by EdK - 06-05-2015, 10:42 AM
RE: Rotary table want to make good decision - by Kennyv - 06-05-2015, 10:49 AM
RE: Rotary table want to make good decision - by EdK - 06-05-2015, 01:23 PM
RE: Rotary table want to make good decision - by f350ca - 06-05-2015, 11:42 AM
RE: Rotary table want to make good decision - by EdK - 06-05-2015, 01:25 PM
RE: Rotary table want to make good decision - by Vinny - 06-05-2015, 04:11 PM
RE: Rotary table want to make good decision - by Kennyv - 06-12-2015, 09:07 AM
RE: Rotary table want to make good decision - by zmotorsports - 06-12-2015, 09:29 AM
|
