06-05-2015, 10:42 AM
For that mill, I'd get the 6". You can always use a larger fixture plate on the 6" if you need a larger surface for some projects. 
Ed
Ed
|
Help Rotary table want to make good decision
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Rotary table want to make good decision - by Kennyv - 06-05-2015, 09:37 AM
RE: Rotary table want to make good decision - by dallen - 06-05-2015, 10:18 AM
RE: Rotary table want to make good decision - by EdK - 06-05-2015, 10:42 AM
RE: Rotary table want to make good decision - by Kennyv - 06-05-2015, 10:49 AM
RE: Rotary table want to make good decision - by EdK - 06-05-2015, 01:23 PM
RE: Rotary table want to make good decision - by f350ca - 06-05-2015, 11:42 AM
RE: Rotary table want to make good decision - by EdK - 06-05-2015, 01:25 PM
RE: Rotary table want to make good decision - by Vinny - 06-05-2015, 04:11 PM
RE: Rotary table want to make good decision - by Kennyv - 06-12-2015, 09:07 AM
RE: Rotary table want to make good decision - by zmotorsports - 06-12-2015, 09:29 AM
|
Users browsing this thread: 2 Guest(s)