06-04-2015, 07:59 PM
A washer the right thickness....now there's a project I could/should latch onto.
One of these days I'll get a hole drilled through some 1" steel stock and part off a series of 1/8", 5/32", 3/16", 1/4" (and so on) thick washers/spacers in pairs. When using the Te-Co step block clamp sets it seems I'm always finding the stud to be just a little too long and I reach for the nail with a bunch of 1/16" thick washers. It would be better to grab ONE that's the right thickness.
One of these days I'll get a hole drilled through some 1" steel stock and part off a series of 1/8", 5/32", 3/16", 1/4" (and so on) thick washers/spacers in pairs. When using the Te-Co step block clamp sets it seems I'm always finding the stud to be just a little too long and I reach for the nail with a bunch of 1/16" thick washers. It would be better to grab ONE that's the right thickness.