exhaust hole it too small, it needs to be at least 4 inches in diameter, or for those that use the metric system 101.6 MM
larger if your going to be using large scrap. you can always block it off with a brick.
But it needs to be large enough that you can put metal to be melted into the crucible without opening the lid.
for the headache from welding on the zink, drink milk.
larger if your going to be using large scrap. you can always block it off with a brick.
But it needs to be large enough that you can put metal to be melted into the crucible without opening the lid.
for the headache from welding on the zink, drink milk.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!