In the Market
#16
(06-03-2015, 09:17 PM)PixMan Wrote: That machine might be a multiple setup challenge for an AR receiver. In fact, most machines smaller than a Bridgeport or clone might have issues with under the spindle height needed for work on the ends.

The RF-45 & clones have 18" under the spindle available. I would think that would be plenty. But then I don't know what's involved in building guns.

Ed
Reply
Thanks given by:


Messages In This Thread
In the Market - by Thumb - 06-03-2015, 05:18 PM
RE: In the Market - by EdK - 06-03-2015, 06:40 PM
RE: In the Market - by DaveH - 06-03-2015, 06:50 PM
RE: In the Market - by dallen - 06-03-2015, 06:53 PM
RE: In the Market - by PixMan - 06-03-2015, 06:54 PM
RE: In the Market - by Thumb - 06-03-2015, 07:56 PM
RE: In the Market - by PixMan - 06-03-2015, 08:04 PM
RE: In the Market - by Thumb - 06-03-2015, 08:21 PM
RE: In the Market - by DaveH - 06-03-2015, 08:45 PM
RE: In the Market - by PixMan - 06-03-2015, 09:17 PM
RE: In the Market - by EdK - 06-04-2015, 05:18 AM
RE: In the Market - by Thumb - 06-03-2015, 09:26 PM
RE: In the Market - by Vinny - 06-03-2015, 09:31 PM
RE: In the Market - by Thumb - 06-03-2015, 10:35 PM
RE: In the Market - by Roadracer_Al - 06-04-2015, 12:47 AM
RE: In the Market - by Thumb - 06-04-2015, 01:08 AM
RE: In the Market - by Thumb - 06-04-2015, 10:25 PM
RE: In the Market - by Thumb - 06-17-2015, 02:14 PM
RE: In the Market - by EdK - 06-17-2015, 04:38 PM
RE: In the Market - by DaveH - 06-17-2015, 05:53 PM
RE: In the Market - by Thumb - 06-17-2015, 06:32 PM
RE: In the Market - by arvidj - 06-17-2015, 07:38 PM
RE: In the Market - by Hopefuldave - 06-17-2015, 07:36 PM
RE: In the Market - by Thumb - 06-17-2015, 07:54 PM
RE: In the Market - by arvidj - 06-17-2015, 08:14 PM
RE: In the Market - by f350ca - 06-17-2015, 10:24 PM



Users browsing this thread: 5 Guest(s)