MetalworkingFun Forum › Machinery › Milling Machines v
In the Market

Thread Modes
In the Market
Thumb Offline
Sophmore
***
Posts: 63
Threads: 10
Joined: Jun 2015
Location: Medford, Or
#13
06-03-2015, 10:35 PM (This post was last modified: 06-03-2015, 10:36 PM by Thumb.)
I have plenty of room, about a 6' x 6' space in my shop that's just sitting there waiting for something but if I can take up less space than that I'd be happy. You never know when something else needs to be had. Big Grin

I also have 220 if needed but would rather stick to 110.
Reply
Thanks given by:


Messages In This Thread
In the Market - by Thumb - 06-03-2015, 05:18 PM
RE: In the Market - by EdK - 06-03-2015, 06:40 PM
RE: In the Market - by DaveH - 06-03-2015, 06:50 PM
RE: In the Market - by dallen - 06-03-2015, 06:53 PM
RE: In the Market - by PixMan - 06-03-2015, 06:54 PM
RE: In the Market - by Thumb - 06-03-2015, 07:56 PM
RE: In the Market - by PixMan - 06-03-2015, 08:04 PM
RE: In the Market - by Thumb - 06-03-2015, 08:21 PM
RE: In the Market - by DaveH - 06-03-2015, 08:45 PM
RE: In the Market - by PixMan - 06-03-2015, 09:17 PM
RE: In the Market - by EdK - 06-04-2015, 05:18 AM
RE: In the Market - by Thumb - 06-03-2015, 09:26 PM
RE: In the Market - by Vinny - 06-03-2015, 09:31 PM
RE: In the Market - by Thumb - 06-03-2015, 10:35 PM
RE: In the Market - by Roadracer_Al - 06-04-2015, 12:47 AM
RE: In the Market - by Thumb - 06-04-2015, 01:08 AM
RE: In the Market - by Thumb - 06-04-2015, 10:25 PM
RE: In the Market - by Thumb - 06-17-2015, 02:14 PM
RE: In the Market - by EdK - 06-17-2015, 04:38 PM
RE: In the Market - by DaveH - 06-17-2015, 05:53 PM
RE: In the Market - by Thumb - 06-17-2015, 06:32 PM
RE: In the Market - by arvidj - 06-17-2015, 07:38 PM
RE: In the Market - by Hopefuldave - 06-17-2015, 07:36 PM
RE: In the Market - by Thumb - 06-17-2015, 07:54 PM
RE: In the Market - by arvidj - 06-17-2015, 08:14 PM
RE: In the Market - by f350ca - 06-17-2015, 10:24 PM



Users browsing this thread: 6 Guest(s)