MetalworkingFun Forum › Machining › Welding & Casting v
Ok, what went wrong?

Thread Modes
Ok, what went wrong?
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
#2
06-01-2015, 05:09 PM (This post was last modified: 06-01-2015, 05:10 PM by dallen.)
could be from slag buildup in the tube at the area of the cut. or one too many Linenkugals  Big Grin

I've seen worse but it was in 2 inch plate

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
Ok, what went wrong? - by Vinny - 06-01-2015, 05:05 PM
RE: Ok, what went wrong? - by dallen - 06-01-2015, 05:09 PM
RE: Ok, what went wrong? - by Vinny - 06-01-2015, 05:21 PM
RE: Ok, what went wrong? - by dallen - 06-01-2015, 05:36 PM
RE: Ok, what went wrong? - by Vinny - 06-01-2015, 05:39 PM
RE: Ok, what went wrong? - by dallen - 06-01-2015, 05:54 PM
RE: Ok, what went wrong? - by f350ca - 06-01-2015, 07:13 PM
RE: Ok, what went wrong? - by PixMan - 06-01-2015, 07:15 PM
RE: Ok, what went wrong? - by Mayhem - 06-02-2015, 07:07 AM
RE: Ok, what went wrong? - by EdK - 06-02-2015, 04:41 PM
RE: Ok, what went wrong? - by stevec - 06-02-2015, 04:59 PM
RE: Ok, what went wrong? - by EdK - 06-02-2015, 05:12 PM
RE: Ok, what went wrong? - by EdK - 06-01-2015, 07:57 PM
RE: Ok, what went wrong? - by Vinny - 06-01-2015, 08:33 PM
RE: Ok, what went wrong? - by EdK - 06-02-2015, 07:05 AM
RE: Ok, what went wrong? - by Vinny - 06-02-2015, 02:29 PM
RE: Ok, what went wrong? - by awemawson - 06-02-2015, 01:43 AM
RE: Ok, what went wrong? - by trevatxtal - 06-02-2015, 02:35 AM
RE: Ok, what went wrong? - by oldgoaly - 06-04-2015, 06:55 AM
RE: Ok, what went wrong? - by Pete O - 06-04-2015, 07:14 AM
RE: Ok, what went wrong? - by Vinny - 06-04-2015, 04:04 PM
RE: Ok, what went wrong? - by Vinny - 06-04-2015, 04:10 PM
RE: Ok, what went wrong? - by DaveH - 06-04-2015, 04:52 PM
RE: Ok, what went wrong? - by Vinny - 06-06-2015, 06:38 PM
RE: Ok, what went wrong? - by oldskoolron - 10-24-2016, 08:12 PM



Users browsing this thread: 4 Guest(s)