05-29-2015, 02:51 PM
This is the "rivet" turned from a (cup square / coach / carriage) bolt. Or whatever they are called.
The bolt is M8, however the part that isn't threaded M8 is only 7mm in diameter
The rivet is not completely a round head because the head dia is 13mm and the depth of the head is 4.5mm. So to make it a proper round head the head dia will need to be 9mm and that is a little small. I may well go for 12mm head dia.
I think I will have to look at some M8 stainless bolts.
DaveH
The bolt is M8, however the part that isn't threaded M8 is only 7mm in diameter
The rivet is not completely a round head because the head dia is 13mm and the depth of the head is 4.5mm. So to make it a proper round head the head dia will need to be 9mm and that is a little small. I may well go for 12mm head dia.
I think I will have to look at some M8 stainless bolts.
DaveH