05-25-2015, 07:38 AM
I removed them to prevent further damage to them, as I want to get them re-done. I can work up the charts in Photoshop easy enough, as they are reproduced in the manual. However, I am going to have to photocopy the logo as well as the letter/number positions for the feed levers.
Here are a couple of (not too good) photos showing the damage to the large nameplate.
The right-hand side of both the metric and inch threading charts are virtually gone. The feed rate charts at the bottom are completely trashed.
Here are a couple of (not too good) photos showing the damage to the large nameplate.
The right-hand side of both the metric and inch threading charts are virtually gone. The feed rate charts at the bottom are completely trashed.
Hunting American dentists since 2015.