05-24-2015, 12:09 AM
Final post is some of the accessories that came with it.
Four jaw chuck, which is 14mm hex driven, rather than the usual square drive. Interestingly it appears to be made by the same company that made Nelly
Two steady rests. The manual lists these as being 12" and 6" capacity but I've not measured them.
A following steady, which will be very helpful. This is listed as 6"
There was also a heavy home made contraption for working on flywheels and clutches, based on what the previous owner told be about the owner prior to him. I'm going to explore making the top part into a faceplate. However, I was much more interested with what currently sits on top. That is a 12" x 10" x 6" angle plate.
I can't recall the exact thickness but it is over an inch thick. Here, that alone would be worth a few hundred dollars.
Here is what I have of the taper turning attachment. I'll have to figure out what is missing.
Four jaw chuck, which is 14mm hex driven, rather than the usual square drive. Interestingly it appears to be made by the same company that made Nelly
Two steady rests. The manual lists these as being 12" and 6" capacity but I've not measured them.
A following steady, which will be very helpful. This is listed as 6"
There was also a heavy home made contraption for working on flywheels and clutches, based on what the previous owner told be about the owner prior to him. I'm going to explore making the top part into a faceplate. However, I was much more interested with what currently sits on top. That is a 12" x 10" x 6" angle plate.
I can't recall the exact thickness but it is over an inch thick. Here, that alone would be worth a few hundred dollars.
Here is what I have of the taper turning attachment. I'll have to figure out what is missing.
Hunting American dentists since 2015.