05-23-2015, 09:32 PM
Truck arrived yesterday and it didn't take long for the driver and me to get the lathe into position using rollers and a large pry bar:
Where I think the feed issue is hiding:
The large Dickson style QCTP. I couldn't' find a manufacturer name or other ID on it. It is big. The nut for the centre post is 36mm and the locking nuts are 18mm.
Found the fluid pipe etc in the chip tray:
Speed controls (20 - 1000 RPM):
Where I think the feed issue is hiding:
The large Dickson style QCTP. I couldn't' find a manufacturer name or other ID on it. It is big. The nut for the centre post is 36mm and the locking nuts are 18mm.
Found the fluid pipe etc in the chip tray:
Speed controls (20 - 1000 RPM):
Hunting American dentists since 2015.