MetalworkingFun Forum › Machinery › Milling Machines v
Wilton Verti-Lock Mill Vise question

Thread Modes
Wilton Verti-Lock Mill Vise question
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
The following 1 user Likes PixMan's post:
EdK (05-20-2015)
#11
05-20-2015, 07:03 PM
That is a virtual copy of my Kurt D675 in every way. The way I described disassembly takes all of ten minutes....if you stop for a cuppa halfway through.
Reply
Thanks given by:


Messages In This Thread
Wilton Verti-Lock Mill Vise question - by Swede56 - 05-18-2015, 11:11 AM
RE: Wilton Verti-Lock Mill Vise question - by EdK - 05-18-2015, 12:35 PM
RE: Wilton Verti-Lock Mill Vise question - by EdK - 05-19-2015, 03:50 PM
RE: Wilton Verti-Lock Mill Vise question - by EdK - 05-19-2015, 04:25 PM
RE: Wilton Verti-Lock Mill Vise question - by EdK - 05-20-2015, 05:16 PM
RE: Wilton Verti-Lock Mill Vise question - by PixMan - 05-20-2015, 07:03 PM
RE: Wilton Verti-Lock Mill Vise question - by EdK - 05-21-2015, 05:51 PM
RE: Wilton Verti-Lock Mill Vise question - by EdK - 05-21-2015, 06:19 PM
RE: Wilton Verti-Lock Mill Vise question - by EdK - 05-22-2015, 04:09 PM
RE: Wilton Verti-Lock Mill Vise question - by EdK - 05-22-2015, 06:29 PM



Users browsing this thread: 1 Guest(s)