MetalworkingFun Forum › Machining › Metrology v
a 0 to 4" micrometre refit

Thread Modes
a 0 to 4" micrometre refit
krv3000 Offline
Senior
*****
Posts: 1,520
Threads: 157
Joined: Feb 2012
Location: uk
The following 1 user Likes krv3000's post:
PixMan (05-18-2015)
#8
05-18-2015, 09:45 AM
hi the inerds have that spray on flock in sum cases its stuck on withe water baste glue but in this cace its not so i just 
let it soke in a buket of hot water  with sope pawder in it 
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
a 0 to 4" micrometre refit - by krv3000 - 05-17-2015, 02:44 PM
RE: a 0 to 4" micrometre refit - by Vinny - 05-17-2015, 02:52 PM
RE: a 0 to 4" micrometre refit - by Micktoon - 05-17-2015, 05:35 PM
RE: a 0 to 4" micrometre refit - by EdK - 05-17-2015, 05:49 PM
RE: a 0 to 4" micrometre refit - by DaveH - 05-17-2015, 06:10 PM
RE: a 0 to 4" micrometre refit - by PixMan - 05-17-2015, 07:31 PM
RE: a 0 to 4" micrometre refit - by stevec - 05-18-2015, 06:14 AM
RE: a 0 to 4" micrometre refit - by krv3000 - 05-18-2015, 09:45 AM



Users browsing this thread: 1 Guest(s)