Where 2 mount ball turner ???

[aRM]

(05-16-2015, 02:33 PM)dallen Wrote: if the ball turner won't reach the work because the cross slide won't travel far enough for the bit to reach the work.

Take a piece of flat bar long enough to fix it and drill two holes in one end so you can bolt it onto the cross slide where the compound attaches, then tap two holes in the other end to bolt the ball turner too.

DA

Sir DALLEN
Ok, this is a bit easier
Just have to watch those holes and replicate them again
U don't like drilling into the Cross Slide ???
aRM