Where 2 mount ball turner ???

[PixMan]

(05-16-2015, 02:33 PM)dallen Wrote: if the ball turner won't reach the work because the cross slide won't travel far enough for the bit to reach the work.

Take a piece of flat bar long enough to fix it and drill two hole in one end so you can bolt it onto the cross slide where the compound attaches, the tap two holes in the other end to bolt the ball turner too.

DA

Exactly what I was suggesting as a fix, but better explained. I did add that one might have to remove a compensating amount of material off the thick base of the tool, equal to the thickness of the plate used.