05-16-2015, 02:10 PM
(05-14-2015, 10:08 AM)PixMan Wrote: You've got a milling machine. Make an new adapter plate to move it forward by the amount needed, face turn the thickness of the plate you make off the bottom of the thick round that it sits on now.
Hello KEN
U giving me more complicated work. Have thought about that as well. And it will take good skill ( like Yours ) to machine that plate, bore the right size hole to match the top section etc etc to move the whole setup forward. No denying it can't be done.
No offence, we were hoping for an easier solution.
Let me think this over the more
aRM