Elliott Concord 460 lathe

[Mayhem]

The manual shows it on the headstock side. I cannot tell from that picture if the small handle is the dog clutch or the spindle control. If it is the dog clutch, it too is on the other side. If it is the spindle control, it is very short compared to mine.

I may make one but as Ken said, I can use the dog clutch. Although, the manual says not to do this for threads below 6tpi. I can't imagine that I will ever need to turn a thread that coarse.

I can see that you guys are going to want lots of details and pictures when I get it...