MetalworkingFun Forum › Machining › General Metalworking Discussion v
Induction Motors

Thread Modes
Induction Motors
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#2
05-14-2015, 06:04 AM
Greg, I'll hafta get a couple of motors out of inventory and try them out with my ammeter.
I'll check back here later (don't hold your breath Rotfl  I sometimes forget Blush ).

Steve

Smiley-eatdrink004
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Induction Motors - by f350ca - 05-13-2015, 10:46 PM
RE: Induction Motors - by stevec - 05-14-2015, 06:04 AM
RE: Induction Motors - by Sunset Machine - 05-14-2015, 07:22 AM
RE: Induction Motors - by Terry S - 05-14-2015, 07:57 AM
RE: Induction Motors - by f350ca - 05-14-2015, 08:28 AM
RE: Induction Motors - by stevec - 05-14-2015, 09:34 AM
RE: Induction Motors - by Terry S - 05-14-2015, 09:58 AM
RE: Induction Motors - by f350ca - 05-14-2015, 12:05 PM
RE: Induction Motors - by stevec - 05-14-2015, 05:54 PM
RE: Induction Motors - by Vinny - 05-14-2015, 06:04 PM
RE: Induction Motors - by f350ca - 05-14-2015, 06:57 PM
RE: Induction Motors - by Roadracer_Al - 05-16-2015, 01:41 PM
RE: Induction Motors - by f350ca - 05-16-2015, 04:35 PM
RE: Induction Motors - by starlight_tools - 05-18-2015, 12:13 AM
RE: Induction Motors - by f350ca - 05-18-2015, 06:32 PM
RE: Induction Motors - by starlight_tools - 05-18-2015, 10:29 PM



Users browsing this thread: 2 Guest(s)