Tooling question for RF-45 clone
#19
Didn't hear of your upcoming knee job when we last spoke Tom. I trust caterpillar won't be doing the work.
Seriously, My wife had a knee replacement in 2011 and they had her up and on it the following day, it's been marvelous.
The only advice I can give is follow your rehab exercises and physio religiously.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Tooling question for RF-45 clone - by DanH - 05-21-2012, 04:20 PM
RE: Tooling question for RF-45 clone - by EdK - 05-21-2012, 06:18 PM
RE: Tooling question for RF-45 clone - by krv3000 - 05-21-2012, 06:19 PM
RE: Tooling question for RF-45 clone - by ETC57 - 05-21-2012, 07:11 PM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 11:00 AM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 11:34 AM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 12:14 PM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 04:38 PM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 04:49 PM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 05:09 PM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 06:12 PM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 07:20 PM
RE: Tooling question for RF-45 clone - by EdK - 05-23-2012, 08:05 AM
RE: Tooling question for RF-45 clone - by stevec - 05-23-2012, 08:03 AM
RE: Tooling question for RF-45 clone - by EdK - 05-24-2012, 07:07 AM
RE: Tooling question for RF-45 clone - by stevec - 05-24-2012, 06:31 AM
RE: Tooling question for RF-45 clone - by Mayhem - 05-25-2012, 01:11 AM
RE: Tooling question for RF-45 clone - by DanH - 05-25-2012, 10:15 AM
RE: Tooling question for RF-45 clone - by ETC57 - 05-25-2012, 11:06 AM



Users browsing this thread: 2 Guest(s)