05-05-2015, 04:50 PM
Steve, the AT102, 111, 112, 115 and 181 are all 0.0005mm - 0.01mm (depending upon the counter connected). The counter is the KS model which is 0.0005mm/0.001mm/0.002mm/0.005mm/.00002"/.00005"/.0001"/.0002"/.0005" (that was a copy/paste from the spec sheet) and the display is 8 digit with - sign and floating decimal point.
Ken, this one has both modes (inc and dia) it's switched with the 1/2 button.
There is one minor drawback with this one. The scales are TOO BIG FOR MY MILL! If I mount them horizontal in the back of the table, I lose 4" of Y travel. If I mount it in the front, I can't turn the Y handle. What I may do is wait till I build the table and re-engineer the Y handle so I can put it on the front.
Unless someone has another idea, of course. *hopeful look*
Ken, this one has both modes (inc and dia) it's switched with the 1/2 button.
There is one minor drawback with this one. The scales are TOO BIG FOR MY MILL! If I mount them horizontal in the back of the table, I lose 4" of Y travel. If I mount it in the front, I can't turn the Y handle. What I may do is wait till I build the table and re-engineer the Y handle so I can put it on the front.
Unless someone has another idea, of course. *hopeful look*
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique
the nobucks boutique etsy shop | the nobucks boutique