05-05-2015, 07:04 AM
Vinny, looks great!
My Mitutoyo died over the winter, after giving me some problems last summer.
I had to remove the on-off switch and wire it direct from the "ON" side of my mill power switch, worked for a while but now there's no response.
I'll look closer into it when I get time so I'm presently re-learning to use the dials.
I'd like to compare the specs of our scales, it might help me find a new controller to talk to them.
I notice your read out goes to 4 decimal places? seems a bit much for a mill?
Steve
My Mitutoyo died over the winter, after giving me some problems last summer.
I had to remove the on-off switch and wire it direct from the "ON" side of my mill power switch, worked for a while but now there's no response.
I'll look closer into it when I get time so I'm presently re-learning to use the dials.
I'd like to compare the specs of our scales, it might help me find a new controller to talk to them.
I notice your read out goes to 4 decimal places? seems a bit much for a mill?
Steve
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.