05-04-2015, 07:44 AM
My DTI instructions say the same thing but I thought that was more to do with taking actual measurements, due to error of cosine. However, I was under the impression that it wouldn't matter when making comparative measurement that you would take when centering a part on the mill, as the error would cancel itself out. Perhaps I'm misunderstanding this?
From Rob's initial pictures, it looks like the holder actually can take the ball swivel adapter that Ken referred to, so all bases seem to be covered.
From Rob's initial pictures, it looks like the holder actually can take the ball swivel adapter that Ken referred to, so all bases seem to be covered.
Hunting American dentists since 2015.