Coke Forge Build

[RobWilson]

A bit more done today   , worked on the air control valve spindle , this was turned and screw cut , then slapped onto the mill like so .




Two flats mill on the screwed section .




Then a section of spindle was milled away for the gate /butterfly .



And then a couple of hole were poked in .




Next a 1 mill thick disc was turned , this needs two slots milled . I used an old bearing race to centre the chuck with the aid of my Zero set indicator (Wilson copy) , just love that tool . 



Then the disc mounted and milled .




Nearly there . 





Rob