MetalworkingFun Forum › Machinery › Milling Machines v
Tooling question for RF-45 clone

Thread Modes
Tooling question for RF-45 clone
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#17
05-22-2012, 07:20 PM
Tom,

These RF-45 clones have a 9" table depth which is the same as a lot of Bridgeports so the 10" RT might fit, but it'll take up a lot of real estate. The nice thing about these mills is the spindle to table distance at about 18" maximum.

Ed
Reply
Thanks given by:


Messages In This Thread
Tooling question for RF-45 clone - by DanH - 05-21-2012, 04:20 PM
RE: Tooling question for RF-45 clone - by EdK - 05-21-2012, 06:18 PM
RE: Tooling question for RF-45 clone - by krv3000 - 05-21-2012, 06:19 PM
RE: Tooling question for RF-45 clone - by ETC57 - 05-21-2012, 07:11 PM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 11:00 AM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 11:34 AM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 12:14 PM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 04:38 PM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 04:49 PM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 05:09 PM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 06:12 PM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 07:20 PM
RE: Tooling question for RF-45 clone - by EdK - 05-23-2012, 08:05 AM
RE: Tooling question for RF-45 clone - by stevec - 05-23-2012, 08:03 AM
RE: Tooling question for RF-45 clone - by EdK - 05-24-2012, 07:07 AM
RE: Tooling question for RF-45 clone - by stevec - 05-24-2012, 06:31 AM
RE: Tooling question for RF-45 clone - by Mayhem - 05-25-2012, 01:11 AM
RE: Tooling question for RF-45 clone - by DanH - 05-25-2012, 10:15 AM
RE: Tooling question for RF-45 clone - by ETC57 - 05-25-2012, 11:06 AM



Users browsing this thread: 4 Guest(s)