05-02-2015, 05:10 PM
Well this project is intent on never getting finished. I started turning the new blank to replace the butchered one and my DRO said I had .025" to go. So I thought I better make a measurement. I should have been at 1.300" but it was at 1.200". I must have keyed in the starting dimension incorrectly. Now I have a nice piece of bronze that I can hopefully use for a bushing in the future.
Ed
EDIT: make that two pieces. The first butchered one and now this new one.
Ed
EDIT: make that two pieces. The first butchered one and now this new one.