05-02-2015, 08:15 AM
My shaper won't stop until the saddle runs off the end of the leadscrew. It needs me. 
The angle plate. If there's room, how about using a lathe to flycut it square? Bolt it down in place of the toolpost and rig up a cutter for the 4-jaw.
Here's one for the horizontal mills.
The angle plate. If there's room, how about using a lathe to flycut it square? Bolt it down in place of the toolpost and rig up a cutter for the 4-jaw.
Here's one for the horizontal mills.