05-01-2015, 08:44 PM
Nice shaper work on the angle plates.
Another option is to hold the rough angle plate on the mill using a 2X4X6 block. Clamp the block to the table and then the weldament to the block. It would probably be a good idea to rough it out using the mill vice and a fly cutter.
If you do not already own the blocks it would be a good time to buy some. http://www.travers.com/31152-57-020-416?...tion||Sets or http://www.shars.com/products/measuring/...sion-block
If you do not have a fly cutter it would be a good time to make one.
Another option is to hold the rough angle plate on the mill using a 2X4X6 block. Clamp the block to the table and then the weldament to the block. It would probably be a good idea to rough it out using the mill vice and a fly cutter.
If you do not already own the blocks it would be a good time to buy some. http://www.travers.com/31152-57-020-416?...tion||Sets or http://www.shars.com/products/measuring/...sion-block
If you do not have a fly cutter it would be a good time to make one.