Refreshing a drill chuck.
#13
(04-30-2015, 06:13 AM)TomG Wrote: I've chucked those up and stoned the tapered bore before. If you use a round stone and a little care, you can remove the galling without screwing up the taper.

Tom

This.

I've done it on many different applications like this over the years, works just fine.
Reply
Thanks given by:


Messages In This Thread
Refreshing a drill chuck. - by Highpower - 04-29-2015, 05:37 PM
RE: Refreshing a drill chuck. - by f350ca - 04-29-2015, 06:47 PM
RE: Refreshing a drill chuck. - by dallen - 04-29-2015, 08:56 PM
RE: Refreshing a drill chuck. - by f350ca - 04-29-2015, 09:17 PM
RE: Refreshing a drill chuck. - by dallen - 04-30-2015, 07:24 AM
RE: Refreshing a drill chuck. - by Vinny - 04-29-2015, 09:21 PM
RE: Refreshing a drill chuck. - by Highpower - 04-29-2015, 11:16 PM
RE: Refreshing a drill chuck. - by TomG - 04-30-2015, 06:13 AM
RE: Refreshing a drill chuck. - by PixMan - 05-01-2015, 08:23 PM
RE: Refreshing a drill chuck. - by Dr Stan - 04-30-2015, 09:56 AM
RE: Refreshing a drill chuck. - by Roadracer_Al - 04-30-2015, 12:02 PM
RE: Refreshing a drill chuck. - by f350ca - 04-30-2015, 07:15 PM
RE: Refreshing a drill chuck. - by Dr Stan - 04-30-2015, 11:40 PM
RE: Refreshing a drill chuck. - by Highpower - 05-02-2015, 12:08 PM
RE: Refreshing a drill chuck. - by TomG - 05-02-2015, 09:30 PM
RE: Refreshing a drill chuck. - by Highpower - 05-02-2015, 11:17 PM
RE: Refreshing a drill chuck. - by Highpower - 05-05-2015, 04:49 PM
RE: Refreshing a drill chuck. - by stevec - 05-05-2015, 05:02 PM
RE: Refreshing a drill chuck. - by Highpower - 05-05-2015, 05:13 PM
RE: Refreshing a drill chuck. - by krv3000 - 05-05-2015, 06:42 PM
RE: Refreshing a drill chuck. - by DaveH - 05-05-2015, 07:09 PM
RE: Refreshing a drill chuck. - by Highpower - 05-05-2015, 08:39 PM
RE: Refreshing a drill chuck. - by stevec - 05-06-2015, 07:10 AM
RE: Refreshing a drill chuck. - by Mayhem - 05-06-2015, 07:19 AM
RE: Refreshing a drill chuck. - by stevec - 05-06-2015, 07:26 AM
RE: Refreshing a drill chuck. - by EdK - 05-06-2015, 08:09 AM
RE: Refreshing a drill chuck. - by Highpower - 05-06-2015, 08:19 AM



Users browsing this thread: 2 Guest(s)