05-01-2015, 06:59 PM
(05-01-2015, 06:06 PM)Vinny Wrote: Can't have a solid top, learned that the hard way. The screw for the knee height will extend below the bottom of the mill when it's down more than half way. Before I bolted it down I cranked it down and wondered why it was leaning backward. It didn't occur to me that the screw was sticking out the bottom until I looked under it. It's sitting on 3/4 ply on top of 3/4 particle board.
It doesn't have to be solid. I have a cut-out in the middle of mine to access the Y lead screw nut.
Ed