How to square up an angle plate

Hello There, Guest! Register

Thread Modes

How to square up an angle plate

EdK

Offline

Whipping Boy

Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota

#9

05-01-2015, 01:33 PM

Nice finish off of that shaper Rob. It looks like it was run through a surface grinder.

Ed

Reply

« Next Oldest | Next Newest »

Messages In This Thread

How to square up an angle plate - by Mayhem - 05-01-2015, 06:42 AM

RE: How to square up an angle plate - by Highpower - 05-01-2015, 07:44 AM

RE: How to square up an angle plate - by Mayhem - 05-01-2015, 07:48 AM

RE: How to square up an angle plate - by PixMan - 05-01-2015, 08:05 AM

RE: How to square up an angle plate - by Mayhem - 05-01-2015, 08:17 AM

RE: How to square up an angle plate - by f350ca - 05-01-2015, 10:18 AM

RE: How to square up an angle plate - by chucketn - 05-01-2015, 10:51 AM

RE: How to square up an angle plate - by RobWilson - 05-01-2015, 01:17 PM

RE: How to square up an angle plate - by Mayhem - 05-01-2015, 02:41 PM

RE: How to square up an angle plate - by RobWilson - 05-01-2015, 02:50 PM

RE: How to square up an angle plate - by EdK - 05-01-2015, 01:33 PM

RE: How to square up an angle plate - by RobWilson - 05-01-2015, 02:27 PM

RE: How to square up an angle plate - by PixMan - 05-01-2015, 06:40 PM

RE: How to square up an angle plate - by Vinny - 05-01-2015, 06:48 PM

RE: How to square up an angle plate - by RobWilson - 05-02-2015, 02:47 AM

RE: How to square up an angle plate - by PixMan - 05-01-2015, 08:28 PM

RE: How to square up an angle plate - by DaveH - 05-01-2015, 08:40 PM

RE: How to square up an angle plate - by Dr Stan - 05-01-2015, 08:44 PM

RE: How to square up an angle plate - by TomG - 05-01-2015, 10:27 PM

RE: How to square up an angle plate - by Vinny - 05-01-2015, 11:14 PM

RE: How to square up an angle plate - by Sunset Machine - 05-02-2015, 08:15 AM

RE: How to square up an angle plate - by PixMan - 05-02-2015, 08:24 AM

Users browsing this thread: 3 Guest(s)