MetalworkingFun Forum › Machining › General Metalworking Discussion v
How to square up an angle plate

Thread Modes
How to square up an angle plate
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#6
05-01-2015, 10:18 AM
This is a timely post, I need a tall angle plate for holding shafts and cylinders when adding bolt circles.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
How to square up an angle plate - by Mayhem - 05-01-2015, 06:42 AM
RE: How to square up an angle plate - by Mayhem - 05-01-2015, 07:48 AM
RE: How to square up an angle plate - by PixMan - 05-01-2015, 08:05 AM
RE: How to square up an angle plate - by Mayhem - 05-01-2015, 08:17 AM
RE: How to square up an angle plate - by f350ca - 05-01-2015, 10:18 AM
RE: How to square up an angle plate - by chucketn - 05-01-2015, 10:51 AM
RE: How to square up an angle plate - by RobWilson - 05-01-2015, 01:17 PM
RE: How to square up an angle plate - by Mayhem - 05-01-2015, 02:41 PM
RE: How to square up an angle plate - by RobWilson - 05-01-2015, 02:50 PM
RE: How to square up an angle plate - by EdK - 05-01-2015, 01:33 PM
RE: How to square up an angle plate - by RobWilson - 05-01-2015, 02:27 PM
RE: How to square up an angle plate - by PixMan - 05-01-2015, 06:40 PM
RE: How to square up an angle plate - by Vinny - 05-01-2015, 06:48 PM
RE: How to square up an angle plate - by RobWilson - 05-02-2015, 02:47 AM
RE: How to square up an angle plate - by PixMan - 05-01-2015, 08:28 PM
RE: How to square up an angle plate - by DaveH - 05-01-2015, 08:40 PM
RE: How to square up an angle plate - by Dr Stan - 05-01-2015, 08:44 PM
RE: How to square up an angle plate - by TomG - 05-01-2015, 10:27 PM
RE: How to square up an angle plate - by Vinny - 05-01-2015, 11:14 PM
RE: How to square up an angle plate - by PixMan - 05-02-2015, 08:24 AM



Users browsing this thread: 2 Guest(s)