05-01-2015, 08:17 AM
Ken I have a F2280.UB.051DC.Z03.04 2" face mill if we are talking carbide, or a 1-3/8" 6 flute end mill in HSS. I don't have a "real" angle to bolt it to but I do have other bits of angle iron kicking around.
I'll have to measure it up. The ends are all over the place, so I wondered if it was worth bolting it to the table and giving them a clean up first? I'm not really sure how best to hold it to start off with.
I'll have to measure it up. The ends are all over the place, so I wondered if it was worth bolting it to the table and giving them a clean up first? I'm not really sure how best to hold it to start off with.
Hunting American dentists since 2015.