MetalworkingFun Forum › Machining › General Metalworking Discussion v
How to square up an angle plate

Thread Modes
How to square up an angle plate
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#3
05-01-2015, 07:48 AM
Yes - but this isn't anywhere near square enough to put on the surface grinder Willie. I think it needs some time on the mill first
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
How to square up an angle plate - by Mayhem - 05-01-2015, 06:42 AM
RE: How to square up an angle plate - by Mayhem - 05-01-2015, 07:48 AM
RE: How to square up an angle plate - by PixMan - 05-01-2015, 08:05 AM
RE: How to square up an angle plate - by Mayhem - 05-01-2015, 08:17 AM
RE: How to square up an angle plate - by f350ca - 05-01-2015, 10:18 AM
RE: How to square up an angle plate - by chucketn - 05-01-2015, 10:51 AM
RE: How to square up an angle plate - by RobWilson - 05-01-2015, 01:17 PM
RE: How to square up an angle plate - by Mayhem - 05-01-2015, 02:41 PM
RE: How to square up an angle plate - by RobWilson - 05-01-2015, 02:50 PM
RE: How to square up an angle plate - by EdK - 05-01-2015, 01:33 PM
RE: How to square up an angle plate - by RobWilson - 05-01-2015, 02:27 PM
RE: How to square up an angle plate - by PixMan - 05-01-2015, 06:40 PM
RE: How to square up an angle plate - by Vinny - 05-01-2015, 06:48 PM
RE: How to square up an angle plate - by RobWilson - 05-02-2015, 02:47 AM
RE: How to square up an angle plate - by PixMan - 05-01-2015, 08:28 PM
RE: How to square up an angle plate - by DaveH - 05-01-2015, 08:40 PM
RE: How to square up an angle plate - by Dr Stan - 05-01-2015, 08:44 PM
RE: How to square up an angle plate - by TomG - 05-01-2015, 10:27 PM
RE: How to square up an angle plate - by Vinny - 05-01-2015, 11:14 PM
RE: How to square up an angle plate - by PixMan - 05-02-2015, 08:24 AM



Users browsing this thread: 4 Guest(s)