05-01-2015, 06:53 AM
Given that I have to make at least two different drawbars (the 1/2-12 seems to be only on the home made tooling that came with the mill), I designed them so that I could colour code them:
I had always wondered why there was a relief cut between the taper and the straight section at the end of the NTMB30 tooling and I found that it comes in very handy for colour coding using thin strips of heat shrink.
I had always wondered why there was a relief cut between the taper and the straight section at the end of the NTMB30 tooling and I found that it comes in very handy for colour coding using thin strips of heat shrink.
Hunting American dentists since 2015.