The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
How to square up an angle plate

Thread Modes
How to square up an angle plate
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#1
05-01-2015, 06:42 AM
Some time ago I needed a way to clamp something to my drill press table, so I made a very crude angle plate.  The job it was intended to do wasn't a precision one by any stretch of the imagination but I would like to be able to use it on my mill.

I'm not quite sure that I know how to go about it though.  Or am I just going to be wasting my time?

Here is the piece in question:

   
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
How to square up an angle plate - by Mayhem - 05-01-2015, 06:42 AM
RE: How to square up an angle plate - by Mayhem - 05-01-2015, 07:48 AM
RE: How to square up an angle plate - by PixMan - 05-01-2015, 08:05 AM
RE: How to square up an angle plate - by Mayhem - 05-01-2015, 08:17 AM
RE: How to square up an angle plate - by f350ca - 05-01-2015, 10:18 AM
RE: How to square up an angle plate - by chucketn - 05-01-2015, 10:51 AM
RE: How to square up an angle plate - by RobWilson - 05-01-2015, 01:17 PM
RE: How to square up an angle plate - by Mayhem - 05-01-2015, 02:41 PM
RE: How to square up an angle plate - by RobWilson - 05-01-2015, 02:50 PM
RE: How to square up an angle plate - by EdK - 05-01-2015, 01:33 PM
RE: How to square up an angle plate - by RobWilson - 05-01-2015, 02:27 PM
RE: How to square up an angle plate - by PixMan - 05-01-2015, 06:40 PM
RE: How to square up an angle plate - by Vinny - 05-01-2015, 06:48 PM
RE: How to square up an angle plate - by RobWilson - 05-02-2015, 02:47 AM
RE: How to square up an angle plate - by PixMan - 05-01-2015, 08:28 PM
RE: How to square up an angle plate - by DaveH - 05-01-2015, 08:40 PM
RE: How to square up an angle plate - by Dr Stan - 05-01-2015, 08:44 PM
RE: How to square up an angle plate - by TomG - 05-01-2015, 10:27 PM
RE: How to square up an angle plate - by Vinny - 05-01-2015, 11:14 PM
RE: How to square up an angle plate - by PixMan - 05-02-2015, 08:24 AM



Users browsing this thread: 1 Guest(s)