Stock racks...what do you use?

[DaveH]

(04-30-2015, 06:04 PM)EdK Wrote: Put some steel shims the thickness of the angle iron between the sloping uprights and the shelf supports and weld them in along with the uprights. No notching needed. Or do what Darren said and not worry about the small gap.  

Ed

Using steel shims is a good idea, I have done that in the past, trouble is with my crap welding it doesn't always look too good By the time I have ground it down and re-welded it a number of times it then decides to warp   Great fun this welding lark.

DaveH