Stock racks...what do you use?

[EdK]

(04-30-2015, 08:18 AM)DaveH Wrote: I don't wish to be picky (yes I do ) but those sloping upright angles are slightly skew, not much the thickness of the angle.
So I will butt weld the vertical uprights to the base. Still means the shelf supports (the outer ones) will need to be notched. I think this is how you did it Darren?
 
DaveH

Put some steel shims the thickness of the angle iron between the sloping uprights and the shelf supports and weld them in along with the uprights. No notching needed. Or do what Darren said and not worry about the small gap.

Ed