Tooling question for RF-45 clone

[DanH]

(05-22-2012, 11:34 AM)EdAK Wrote:

(05-22-2012, 11:00 AM)DanH Wrote: Thanks for the feedback guys. It looks like the 8" is the way to go. ENCO has a 10% off and free shipping this week so it's a good time to pull the trigger. They have 2 to choose from. One of them can be setup perpendicular to the table in addition to horizontal. The weight goes up from 80 lbs to 129 lbs which is not so good for my back but it also only costs about $10 more. What do you guys think?

DanH

Dan,

I think your weights are wrong. The horizontal only is 55lbs and the vertical/horizontal is 95lbs.

http://www.use-enco.com/CGI/INPDFF?PMKAN...&PMCTLG=01

I would definitely go with the vertical/horizontal one. It's much more versatile. YMMV

Ed

Your right Ed, I was looking a the weights for the table set.
Dan