Stock racks...what do you use?

[DaveH]

(04-29-2015, 07:33 PM)PixMan Wrote:

(04-28-2015, 06:53 PM)DaveH Wrote: It may be beneficial if Ken could tell us how his rack was made.
 
DaveH

LOL....made by Union labor here in Massachusetts with American made steel.

No idea really, it's a commercially made Hodge Manufacturing Co, formerly of Springfield MA.

Ken,
  I didn't mean that, I meant which bit is welded to which bit. eg the top angle iron I can't see exactly where that is welded. Also the sloping angle is it cut at the top to fit, or is the rear upright angles cut so the sloping angle fits?

I think it is so well designed to use only one eighth thick angle iron. If one looks at it closely it is nearly impossible to find a fault with it and whoever designed it did it really well.

DaveH