Stock racks...what do you use?

[DaveH]

(04-27-2015, 09:39 PM)PixMan Wrote: I don't think it would be safe to leave it free-standing away from a wall without lagging it to the floor....IF there's a lot of longer stock leaning on the angled side without compensating "ballast" of full, heavy shelves.

I can use some (4) rawl bolts and fix it to the concrete floor. I thought about extending the angle iron to make a larger base (good for tripping over ) I could make it double sided but I would still have to be careful balancing each side.

I have a lot of metal 3meters long (10 foot) - not round bar, mainly square/round tubing, angle iron, flat bar all different sizes it would be nice to get it off the floor? I don't like cutting if smaller - tends to be wasteful, especially if I want a couple pieces of angle 2100mm long and I have cut it 1500mm long

DaveH