Tooling question for RF-45 clone

[henryarnold]

I bought a 6" Rotary Table that is similar to a Phase II. I've used it for many projects but needed something bigger.
   

So I added a 14" x 3/4" aluminum plate. The plate is registered by a pin in the middle that fits into the MT hole of the table and bolts to the rotary table's T slots with recessed cap screws.
   

The plate was machined on the rotary table. I used the rotary table to machine the outside edge and all of the mounting holes. Now I can create any round or arced object up to 7" radius.