04-27-2015, 08:48 AM
I must be getting senile the distributor is driven off the camshaft at 2-1 ratio, not the accessory shaft,
May be it's just square eyes from looking at this computer.
I will rub out the error later when I put in the prop flange ETC.
Brian.
May be it's just square eyes from looking at this computer.
I will rub out the error later when I put in the prop flange ETC.
Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com
http://briansworkshop.weebly.com