04-26-2015, 09:27 AM
Other than the use of the larger (better, stronger) 2" angle iron, the only difference I see between that one and mine is the angle iron across the forward side of each shelf. If I recall correctly, on mine the shelves are a single sheet of steel with the front side bent up to 90º. You would have to do yours the way you did because I don't believe you own a large press brake for bending sheet metal that big and thick.
Really top-notch work there! You could probably make and sell a few of them at a profit!
One little detail that might help yours (and mine) might be adding a little bar across the midpoint of the bottom space on the angled front uprights. I have a number of shorter bars that take up too much room lying horizontal on the shelves, but I can't stand them on end because they'd fall through.
Really top-notch work there! You could probably make and sell a few of them at a profit!
One little detail that might help yours (and mine) might be adding a little bar across the midpoint of the bottom space on the angled front uprights. I have a number of shorter bars that take up too much room lying horizontal on the shelves, but I can't stand them on end because they'd fall through.