Checking My Nuts

[EdK]

(04-25-2015, 11:41 PM)Highpower Wrote: ...
I thought this sounded familiar. Not trying to crack wise Ed, but could this possibly be a case of Déjà vu all over again? 

http://www.metalworkingfun.com/showthrea...8#pid27908

My lathe chart says I can use any NUMBERED line as well. 

Willie,

That's the first thing I thought of and checked it. At least I learned that lesson.  

The last thread I cut was the practice 10TPI acme thread I cut in aluminum. I had to change the gears to get my power feeds back to normal for boring but that doesn't involve swapping that lower gear and spacer so I didn't think that would be the problem, but I checked anyway, multiple times.

Ed