Tooling question for RF-45 clone

[EdK]

(05-21-2012, 04:20 PM)DanH Wrote: I am thinking of getting a Phase II rotary table for my mill and would like recommendations on which size to get. I assume it would be between the 6" and 8" sizes but would like to hear from you more experienced guys.

DanH

Dan,

I got an 8" for my RF-45 clone. I was going to go with a 6" but was talked into going with the 8" instead by people that bought the 6" and wished they had gotten the 8". It's probably the biggest size that will fit on our mills comfortably. I haven't used mine a lot yet but it sure is nice to have when you need it. YMMV

Ed