04-22-2015, 01:08 PM
(04-22-2015, 11:35 AM)EdK Wrote:(04-22-2015, 07:43 AM)dallen Wrote: were all the changes to the prints posted as a new pdf for download?
Just asking as the last attached file I see still shows the crank pin offset as .750 instead of 1" as per Billy G
See this: http://www.metalworkingfun.com/showthrea...9#pid42899
Ed
Page 8 of the drawings still shows the offset of the pin as .750" instead of the 1" as noted in message 156
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!