05-21-2012, 07:33 AM
Hi,
Yeah have progressed a bit further with it, lets see if i can add pictures here
Turned the bar between centres in the trusty Myford
![[Image: 2012-05-02114819.jpg]](http://i145.photobucket.com/albums/r226/asf007/Workshop/2012-05-02114819.jpg)
Arrived at the point where i needed the correct size of thread that i asked about
![[Image: 2012-05-21115625.jpg]](http://i145.photobucket.com/albums/r226/asf007/Workshop/2012-05-21115625.jpg)
Popped the thread on
![[Image: 2012-05-21114332-1.jpg]](http://i145.photobucket.com/albums/r226/asf007/Workshop/2012-05-21114332-1.jpg)
Now I try it on the new MT3 collet Success !
![[Image: 2012-05-21115553.jpg]](http://i145.photobucket.com/albums/r226/asf007/Workshop/2012-05-21115553.jpg)
All that is needed now is my jig completing so that i can add the squared off end for the spanner to fit
![[Image: 2012-05-21114419-1.jpg]](http://i145.photobucket.com/albums/r226/asf007/Workshop/2012-05-21114419-1.jpg)
Yeah have progressed a bit further with it, lets see if i can add pictures here
Turned the bar between centres in the trusty Myford
Arrived at the point where i needed the correct size of thread that i asked about
Popped the thread on
Now I try it on the new MT3 collet Success !
All that is needed now is my jig completing so that i can add the squared off end for the spanner to fit
Andy 
b4dyc, proud to be a member of MetalworkingFun Forum since Apr 2012. Oh yeah
b4dyc, proud to be a member of MetalworkingFun Forum since Apr 2012. Oh yeah