(04-14-2015, 05:09 PM)DaveH Wrote: For external turning the insert holder is designated SCLCR 1212F 09Heck DAVE, like KEN U Guys are literally walking encyclopaedias. And are we lucky to have U Guys here !!!
The SCLCR means the same as before. The 1212 is the size of the shank in this case it is 12mm x 12mm so it is a square shank by F mm long.
I do have one that is 1616H, still takes the 09 insert, the F and the H denote the total length 80mm and 100mm respectfully.
So the majority of my insert holders all take the same insert size 09. For me it helps to have only a single type and size insert to buy.
I'm sure I have confused you somewhat - just ask some questions.
DaveH
OK. U have a specific Insert size with all round Toolholders. Now that's clever.
Initially we would like to get an Positive external Turning Holder so we would call for an SCLR 2020F 09, right, as our QCTP takes a 20 mm Height shank.
Hope I am understanding U correctly here.
The Boring Bar will follow, LORD Willing. Your explanation on the width of the Bar and the actual Bore size applicable was quite enlightening. Does pay to know to know these things !!!
Thanks a stack
Need to go out and look at Prices.
aRM