04-14-2015, 12:12 PM
Hey everyone,
I hate to say it but after a decent amount of time trying to find a replacement for that part, i still have failed.
I managed to find JT3/MT3 arbor and chuck, the first one i ordered didn't have an opening on one side for a draw bar. The second had an opening for a drawbar but it was not the same thread size and the draw bar would not fit into it.
I went down to a local tool supply and they seemed pretty surprised by it told me they didn't think they had what i needed.
I noticed in here there was a diagram of it (http://www.micromark.com/html_pages/inst...e-inst.pdf) since i believe that to be the manual i was hoping it would be the right one.
The picture is pretty poor quality but I was wondering if anyone who might know what to look for could point me towards the correct part?
thanks! if milling is half as hard as finding this part, getting a little worried
I hate to say it but after a decent amount of time trying to find a replacement for that part, i still have failed.
I managed to find JT3/MT3 arbor and chuck, the first one i ordered didn't have an opening on one side for a draw bar. The second had an opening for a drawbar but it was not the same thread size and the draw bar would not fit into it.
I went down to a local tool supply and they seemed pretty surprised by it told me they didn't think they had what i needed.
I noticed in here there was a diagram of it (http://www.micromark.com/html_pages/inst...e-inst.pdf) since i believe that to be the manual i was hoping it would be the right one.
The picture is pretty poor quality but I was wondering if anyone who might know what to look for could point me towards the correct part?
thanks! if milling is half as hard as finding this part, getting a little worried